adafruit_cap1188.cap1188
CircuitPython driver for the CAP1188 8-Key Capacitive Touch Sensor Breakout.
Author(s): Carter Nelson, Jeremiah Rose, Jose David M.
Implementation Notes
Hardware:
CAP1188 - 8-Key Capacitive Touch Sensor Breakout (Product ID: 1602)
Software and Dependencies:
Adafruit CircuitPython firmware for the supported boards: https://circuitpython.org/downloads
Adafruit’s Bus Device library: https://github.com/adafruit/Adafruit_CircuitPython_BusDevice
- class adafruit_cap1188.cap1188.CAP1188
CAP1188 driver base, must be extended for I2C/SPI interfacing.
- property averaging: int
Samples that are taken for all active channels during the sensor cycle. All samples are taken consecutively on the same channel before the next channel is sampled and the result is averaged over the number of samples measured before updating the measured results
if CS1, CS2, and CS3 are sampled during the sensor cycle, and the AVG[2:0] bits are set to take 4 samples per channel, then the full sensor cycle will be: CS1, CS1, CS1, CS1, CS2, CS2, CS2, CS2, CS3, CS3, CS3, CS3.
- property cycle: str
The programmed cycle time is only maintained if the total averaging time for all samples is less than the programmed cycle. The AVG[2:0] bits will take priority so that if more samples are required than would normally be allowed during the cycle time, the cycle time will be extended as necessary to accommodate the number of samples to be measured.
- property sample: str
Determines the overall cycle time for all measured channels during normal operation. All measured channels are sampled at the beginning of the cycle time. If additional time is remaining, then the device is placed into a lower power state for the remaining duration of the cycle.
- threshold_values() Tuple[int, int, int, int, int, int, int, int]
Return tuple of touch threshold values for all channels.
- class adafruit_cap1188.cap1188.CAP1188_Channel(cap1188: CAP1188, pin: int)
Helper class to represent a touch channel on the CAP1188. Not meant to be used directly.
adafruit_cap1188.i2c
CircuitPython I2C driver for the CAP1188 8-Key Capacitive Touch Sensor Breakout.
Author(s): Carter Nelson
Implementation Notes
Hardware:
CAP1188 - 8-Key Capacitive Touch Sensor Breakout (Product ID: 1602)
Software and Dependencies:
Adafruit CircuitPython firmware for the supported boards: https://circuitpython.org/downloads
Adafruit’s Bus Device library: https://github.com/adafruit/Adafruit_CircuitPython_BusDevice
- class adafruit_cap1188.i2c.CAP1188_I2C(i2c: I2C, address: int = 41)
Driver for the CAP1188 connected over I2C.
adafruit_cap1188.spi
CircuitPython SPI driver for the CAP1188 8-Key Capacitive Touch Sensor Breakout.
Author(s): Carter Nelson
Implementation Notes
Hardware:
CAP1188 - 8-Key Capacitive Touch Sensor Breakout (Product ID: 1602)
Software and Dependencies:
Adafruit CircuitPython firmware for the supported boards: https://circuitpython.org/downloads
Adafruit’s Bus Device library: https://github.com/adafruit/Adafruit_CircuitPython_BusDevice
- class adafruit_cap1188.spi.CAP1188_SPI(spi: SPI, cs: DigitalInOut)
Driver for the CAP1188 connected over SPI.